First it isimportant to have all your products readily at hand and of course a mirror willbe necessary.  Be sure that your system as well as your scalp isabsolutely clean and free from dirt and oil and both your head and systemshould be dry.  For the benefit of your skin it is recommended that youapply a skin cleaner to remove any additional oil on the scalp and if availableapply a thin layer of Scalp Prep to protect your scalp after the system ison.  If you’re wearing a tape on system, wipe the tape tab area with some99% alcohol to assure there is no residue or oil on the tape tab area. Apply your tape, lifting the liner in areas where you’re overlappingstrips. 

Once your tape is in place remove the liner.  Have yourexisting hair clean dry and styled then pick up your system holding the fronttowards you with the back away from you and have the base inverted. Inverting the base will keep the hair from getting on the tape.  Locatethe center front of you hair line and gently place the front of the system atthis point then gently roll the system back into place on your scalp. Check your placement and if your happy with it press the tape onto yourscalp.  If you find you are a little crooked with your placement gentlypull the system off going from back to front, readjust the placement and repeatthe procedure. 

Once the system is in place style the hair into yourexisting hair and you should be ready to go.wigs for sale  After a few tries thisaction becomes second nature. If you’reusing a full head bond you are probably using an adhesive so your preparation willbe slightly different.  Again, it is important to have system, hair andscalp completely clean and free from dirt and oil.  It is particularlyimportant to prepare the scalp utilizing a scalp cleaner and scalp prep. The cleaner has an astringent value that will close the pores and the scalpprep will coat the skin on the scalp to keep potential bacteria from makingit’s way into the skin.  If you’re wearing a skin system, wipe the basewith 99% alcohol and allow to completely dry. 

Once the base is dry applya thin layer of your adhesive and allow the adhesive to get slightlytacky.  Apply a thin layer of adhesive to your scalp and also allow theadhesive to get slightly tacky.  Once the scalp and base are ready followthe directions above for applying the system.  It is very important with afull head bond to do this procedure correctly the first time. 

As you rollthe system back onto your scalp press is gently down to eliminate any bubblesor wrinkles.  Once you have the system on and in place gently press theentire system allowing the adhesive on the base and scalp to bondtogether.  If you’re doing a full head bond with lace, follow the sameprocedure only eliminate putting the adhesive on the base of the system andapply two thin layers of the adhesive to the scalp allowing the first to drybefore applying the second layer and letting the second layer get tacky, thenapply the lace system to the head in the same manner as the skin.